Industrial Covert Unlimited is in its 25rd year of operation. CU1.COM has been up and running since mid 1997 and was one of the original security equipment buying sites on the internet. Great security & CCTV products and people who still answer the phone!
Check Out Our CYBER WEEK DEALS!
Nitek VR148UTP IP Video Network Extender With PoE Injector - Up To 1 Mile
The Nitek VR148UTP long range IP video network extender and PoE inserter allows IP Ethernet transmission of network data over UTP cable for distances up to 1 mile (1,600 meters). In addition, the transmitter will convert the 24VAC used to power standard analog cameras to PoE for the installation of the new IP cameras.
The VR148UTP long range IP video network extender and PoE inserter consists of a transmitter and receiver set which requires very little installation time and absolutely no set up or configuration. Installation requires simply connecting the wire pairs at each end of the existing UTP cable to the transmitter and receiver of the VR148UTP. Once powered up the transmitter will produce PoE for its connected device. The receiver instantly connects to the transmitter and begins operating as a full-duplex 100BaseT Ethernet conduit.
The VR148UTP is completely transparent to the network; it has no IP or MAC addresses and does not require any additional setup or programming. Connect your network devices by plugging their RJ45 connectors into the network port of the transmitter and receiver. LEDs on the devices indicate the presence of power, transmission link and network signals for easy troubleshooting.
The Nitek VR148UTP IP video network extender extends network communications to overcome cable distance limitations offering connections to devices in locations traditional networking does not allow. The VR148UTP will auto-negotiate bandwidth to compensate for wire attenuation and losses that occur from wire length, signal noise and interference. (Please refer to cable distance and bandwidth charts for further review).
These Nitek units are constructed of industrial grade RoHS compliant plated steel which is finished with a heat resistant powder coat paint making them very durable. They are designed to mount within the camera housing, in an equipment enclosure or simply wall mount the unit using the included mounting kit. For installation of several units the RK124 rack mount kit allows for centralized power of the receiver units while maintaining an orderly installation.